New Frsky Air Protocol – ACCESS

If you are a long time Frsky user, you probably recognize the word “ACCST” printed at the bottom left of the Taranis display. ACCST is a TX protocol and it will be soon be replaced by a new protocol – ACCESS.

ACCESS stands for Advanced Communication Control, Elevated Spread Spectrum. It’s the RF protocol that carries the signal from the radio to the receiver, what I would normally call the air protocol or TX protocol.

The existing protocol is ACCST which has been around for more than 10 years, you can find the label at the bottom left of your Taranis X9D display. ACCESS is the upgrade of ACCST.

I will discuss the new features and performance improvements that ACCESS will bring to the table.

Performance improvements includes:

  • Lower latency and higher baud rate
  • Better security
  • Up to 24 full range channel support

One thing I am not sure about is, SBUS and FPort can only transmit 16 channels, so I am not sure if there will be changes to the receiver protocol as well to support the remaining eight extra channels. If so, let’s hope the extra channels doesn’t impact latency like SBUS does. Currently, if we are using SBUS, we tend to only use 8 channels due to the lower latency even though we have the choice to use 16 channels.

ACCESS allows you to bind and flash new receiver firmware wirelessly. I found this to be one of the most exciting new features. TBS has been doing this on the Crossfire for years and I am glad Frsky finally caught up! Frankly, currently flashing new receiver firmware to Frsky receivers is quite annoying, hopefully it would make it a lot easier with this wireless method.

As far as I know, ACCESS will be supported on most of the current Frsky receivers and transmitters, so hopefully you won’t have to buy new hardware in order to enjoy the new protocol and features.

ACCESS will be first come with Frsky’s new radio, the Taranis X9 Lite. It will be made available for existing radios in the form of firmware update later hopefully. I am glad Frsky is making this possible for existing customers and not forcing them to buy brand new gear.

ACCESS firmware for receivers are already available for download on Frsky’s website, but only for five receivers at the time of writing (May 2018): RXSR, RX6R, RX4R, G-RX6 and G-RX8. Note that there are

For more info: https://www.frsky-rc.com/frsky-advanced-communication-control-elevated-spread-spectrum-access-protocol-release/

Maybe, but not right now.

First of all, I have no plan of reviewing the X9 Lite, and I have no idea when it will be made available on the Taranis X9D.

Secondly, I expect there will be bugs with new technology. I will probably wait until most of the bugs are fixed.

But eventually I will give this a try 🙂

It’s great that Frsky is finally improving their technology to catch up with TBS! And this will also make them more competitive against other players like Jumpers.

Source link

Leave a Reply

Leave a Reply

Your email address will not be published. Required fields are marked *